Add to Cart
Special offer on ELG-100-36A meanwell driver 2.66A waterproof led driver ip67
75W~240W
100~305VAC input range
Constant current (C.C.) output
Built-in active PFC function
No load/standby power consumption <0.5W
Metal case, IP67/IP65 design for indoor or outdoor installations
Function options:
output adjustable via potentiometer; 3 in 1 dimming (0~10Vdc or 10V PWM signal or resistance, dim-to-off); smart timer dimming; DALI; auxiliary DC output (ELG-150-C BE-Type)
Type "HL" LED drivers for use in Class I, Division 2 hazardous (Classified) location luminaries
Suitable for LED street lighting and outdoor LED lighting
5 years warranty
MODEL | ELG-100-24 | ELG-100-36 | ELG-100-42 | ELG-100-48 | ELG-100-54 | |
OUTPUT | DC VOLTAGE | 24V | 36V | 42V | 48V | 54V |
CONSTANT CURRENT REGION Note.2 | 12 ~ 24V | 18 ~ 36V | 21 ~ 42V | 24 ~ 48V | 27 ~ 54V | |
RATED CURRENT | 4.0A | 2.66A | 2.28A | 2A | 1.78A | |
RATED POWER | 200VAC ~ 305VAC | |||||
96W | 95.76W | 95.76W | 96W | 96.12W | ||
100VAC ~ 180VAC | ||||||
70W | 70W | 70W | 70W | 70W | ||
RIPPLE & NOISE (max.) Note.3 | 200mVp-p | 250mVp-p | 250mVp-p | 300mVp-p | 350mVp-p | |
VOLTAGE ADJ. RANGE | Adjustable for A-Type only (via the built-in potentiometer) | |||||
21.6 ~ 26.4V | 32.4 ~ 39.6V | 37.8 ~ 46.2V | 43.2 ~ 52.8V | 48.6 ~ 59.4V | ||
CURRENT ADJ. RANGE | Adjustable for A-Type only (via the built-in potentiometer) | |||||
2 ~ 4A | 1.33 ~ 2.66A | 1.14 ~ 2.28A | 1 ~ 2A | 0.89 ~ 1.78A | ||
VOLTAGE TOLERANCE Note.4 | ±3.0% | ±2.5% | ±2.5% | ±2.0% | ±2.0% | |
LINE REGULATION | ±0.5% | ±0.5% | ±0.5% | ±0.5% | ±0.5% | |
LOAD REGULATION | ±1.0% | ±1.0% | ±0.5% | ±0.5% | ±0.5% | |
SETUP, RISE TIME Note.6 | 1000ms, 80ms/115VAC 500ms, 100ms/230VAC | |||||
HOLD UP TIME (Typ.) | 15ms/115VAC 10ms/230VAC | |||||
INPUT | VOLTAGE RANGE Note.5 | 100 ~ 305VAC 142 ~ 431VDC (Please refer to "STATIC CHARACTERISTIC" section) |
||||
FREQUENCY RANGE | 47 ~ 63Hz | |||||
POWER FACTOR | PF≧0.97/115VAC, PF≧0.95/230VAC, PF≧0.92/277VAC@full load (Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section) |
|||||
TOTAL HARMONIC DISTORTION | THD< 20%(@load≧50%/115VC; @load≧60%/230VAC; @load≧75%/277VAC) (Please refer to “TOTAL HARMONIC DISTORTION(THD)” section) | |||||
EFFICIENCY (Typ.) | 88% | 89% | 90% | 90% | 91% | |
AC CURRENT | 1.1A / 115VAC 0.6A / 230VAC 0.5A/277VAC | |||||
INRUSH CURRENT(Typ.) | COLD START 60A(twidth=850μs measured at 50% Ipeak) at 230VAC; Per NEMA 410 | |||||
MAX. No. of PSUs on 16A CIRCUIT BREAKER | 3 units (circuit breaker of type B) / 6 units (circuit breaker of type C) at 230VAC | |||||
LEAKAGE CURRENT | <0.75mA / 277VAC | |||||
NO LOAD / STANDBY POWER CONSUMPTION | No load power consumption <0.5W for Blank / A / Dx / D2-Type Standby power consumption <0.5W for B / DA-Type | |||||
PROTECTION | OVER CURRENT | 95 ~ 108% | ||||
Constant current limiting, recovers automatically after fault condition is removed | ||||||
SHORT CIRCUIT | Hiccup mode, recovers automatically after fault condition is removed | |||||
OVER VOLTAGE | 28 ~ 34V | 41 ~ 48V | 47 ~ 54V | 54 ~ 62V | 62 ~ 72V | |
Shut down output voltage, re-power on to recover | ||||||
OVER TEMPERATURE | Shut down output voltage, re-power on to recover | |||||
ENVIRONMENT | WORKING TEMP. | Tcase=-40 ~ +90℃ (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section) | ||||
MAX. CASE TEMP. | Tcase=+90℃ | |||||
WORKING HUMIDITY | 20 ~ 95% RH non-condensing | |||||
STORAGE TEMP., HUMIDITY | -40 ~ +80℃, 10 ~ 95% RH | |||||
TEMP. COEFFICIENT | ±0.03%/℃ (0 ~ 60℃) | |||||
VIBRATION | 10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes | |||||
SAFETY & EMC | SAFETY STANDARDS | UL8750(type”HL”), CSA C22.2 No. 250.13-12; ENEC EN61347-1, EN61347-2-13 independent, EN62384; GB19510.1, GB19510.14; IP65 or IP67 approved | ||||
DALI STANDARDS | Compliance to IEC62386-101, 102, 207 for DA-Type only | |||||
WITHSTAND VOLTAGE | I/P-O/P:3.75KVAC I/P-FG:2.0KVAC O/P-FG:1.5KVAC | |||||
ISOLATION RESISTANCE | I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25℃/ 70% RH | |||||
EMC EMISSION | Compliance to EN55015,EN61000-3-2 Class C (@load≧60%); EN61000-3-3;GB17743, GB17625.1 | |||||
EMC IMMUNITY | Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level (surge immunity Line-Earth 6KV, Line-Line 4KV) | |||||
OTHERS | MTBF | 978.2K hrs min. Telcordia SR-332 (Bellcore) 282.9Khrs min. MIL-HDBK-217F (25℃) | ||||
DIMENSION | 199*63*35.5mm (L*W*H) | |||||
PACKING | 0.75kg; 16pcs/13kg/0.72CUFT |
Main Export Markets:
Competitive:
1. Ableled lighting Co.,Ltd is a professional project lighting manufacture and is the reputable Meanwell driver agent in Shenzhen.
2. The company offers a series of quality project lighting products ranging from LED high bay, LED floodlight, LED street, Battery floodlight, LED panel, Tri-proof light and the Meanwell dirvers used in these project lighting and commercial lightings.
3. We have enough stock to make sure the delivery time of large quantity, lead time can be immediately.